Call (855) 671-4316
Water removalWater extractionStructural dryingFlood and sewage cleanup

What causes pipes to burst?

Short answer: Pipes usually split because of pressure, not simply because ice expands inside them. Freezing can trap water behind an ice blockage, while excessive supply pressure and years of strain can weaken joints and fittings until they fail.

How freezing leads to a break

When water freezes inside a pipe, ice blocks the flow. If a faucet is closed, water trapped between the ice and the faucet can build up enormous pressure. That pressure may split the pipe, sometimes in a section where no ice formed. So the ice blockage starts the problem, but pressure in the trapped water causes the break (Spokane County).

Pipes are most vulnerable where they lack heat or insulation and cold air can reach them. Attics, crawl spaces, garages, unheated areas, exterior walls and outdoor hose connections are common trouble spots. Moving cold air can freeze a pipe even when the temperature is above 20 degrees, so that threshold is not a guarantee of safety (IBHS, American Red Cross).

Where to check in Valley homes

San Fernando Valley homes can have slab floors and attic air handlers. Those features make it useful to know where plumbing runs and where the main shutoff is, especially before cold weather arrives. Check exposed lines near attics and exterior walls; a pipe’s location, lack of insulation and exposure to cold air matter more than whether it is copper or PVC (IBHS, American Red Cross).

Can high water pressure split pipes?

Yes. Residential water pressure commonly ranges from 45 to 80 psi, and pressure above 80 psi carries a significantly higher risk of damage to pipes, joints, fixtures and seals. A pressure reducing valve lowers incoming pressure; it is often required by code above 80 psi and is commonly set at 45 psi from the factory (City of Green River).

High pressure can also cause strain that accumulates over time. Joints may eventually fail, faucets and fixtures can leak, and appliances can wear down. A hammering noise when water is turned on can signal high pressure. Water discharging from a water heater’s relief valve can point to a faulty pressure regulator, so have a licensed plumber assess it (City of Lincoln, California).

Ways to reduce the risk

A few practical steps help protect exposed plumbing during cold weather and reduce strain from excess pressure. In the San Fernando Valley, check vulnerable pipe locations ahead of a cold spell rather than relying on the usual climate to keep every area of a home warm (IBHS, American Red Cross).

  • Let cold water drip from a faucet served by exposed pipes during very cold weather (IBHS).
  • Open kitchen and bathroom cabinet doors so warmer room air can reach the plumbing (American Red Cross).
  • If leaving during cold weather, keep the heat on at no lower than 55 degrees F (American Red Cross).
  • Insulate exposed pipes and close cracks or openings that let cold air flow across them (IBHS).
  • Keep water pressure at 80 psi or less; ask a plumber about a pressure reducing valve if it is higher (City of Green River).

Thaw a frozen pipe safely

If a pipe freezes, use an electric heating pad, hair dryer, portable space heater kept away from flammable materials, or towels soaked in hot water. Never use a blowtorch, kerosene or propane heater, charcoal stove or another open flame. If you cannot safely reach the frozen section or water is already leaking, stop and get professional help (American Red Cross).

What to do when a pipe breaks

Close the main water shutoff to stop more water from entering the home. Keep clear of outlets and cords that have become wet, and take pictures of the damage. In a Valley home with slab floors or attic plumbing, water may not be limited to the spot where it first appears, so report what you can see and where the leak may have started.

Call a plumber to address the broken pipe, and contact a restoration company for water removal, drying and cleanup. Drying wet areas and items within 24 to 48 hours helps prevent mold growth. 818 Damage is a referral service that connects callers with an independent restoration company; it is not a restoration company itself (EPA).

Common questions

Can pipes freeze when it is above 20 degrees?

Yes. Pipes exposed to cold, moving air can freeze even above the 20-degree threshold. Pipes in attics, crawl spaces, exterior walls and other poorly heated areas are more vulnerable, especially if they have little insulation.

Does ice expanding inside a pipe cause the break?

The ice blocks the pipe, but the damaging pressure usually builds in water trapped between that blockage and a closed faucet. That pressure can split a different section of pipe where no ice formed.

What does a hammering noise in the plumbing mean?

A hammering noise when water is turned on can be a sign of high water pressure. Since pressure above 80 psi increases the risk of damage to pipes, joints and fixtures, ask a licensed plumber to check the pressure and regulator.

Can I use a torch to thaw a frozen pipe?

No. Do not use a blowtorch or another open flame to thaw plumbing. Safer options include a hair dryer, electric heating pad, a portable space heater kept away from flammable materials, or towels soaked in hot water.

More homeowner questions

Sources

Call (855) 671-4316

Last updated

Call (855) 671-4316