Call (855) 671-4316
Water removalWater extractionStructural dryingFlood and sewage cleanup

Water damage help

Water extraction: what to know

Water extraction uses pumps, wands and weighted carpet tools to pull water out mechanically, which is much faster than letting it evaporate.

Water extraction is the mechanical part of the job: truck-mounted or portable units pull water out of carpet, pad and hard floors so drying equipment can work. In the San Fernando Valley, extraction usually happens on the first visit, right after the source is shut off.

Carpet pad acts like a sponge and is often pulled and discarded after extraction, while the carpet itself may be dried in place if the water was clean. Whatever stays should be dry within 24 to 48 hours[EPA].

Gloved hand running a carpet extraction wand across wet carpet

Typical steps

  1. Source off. Water shut off at the main or fixture.
  2. Extract. Carpet, pad and hard floors extracted until little water comes up.
  3. Pull pad if needed. Soaked pad is removed so the floor underneath can dry.
  4. Dry and measure. Equipment runs until readings show dry.

Do

  • Keep foot traffic off wet carpet.
  • Move rugs and loose items off wet floors.

Avoid

  • Leaving wet rugs folded on the floor.
  • Closing up the house with heaters running to “dry things out.”

Signs you need water damage restoration, not just a mop

  • Baseboards or door casings are swelling
  • Vinyl plank or laminate is lifting or cupping
  • Stains are spreading on a ceiling or wall
  • Water reached cabinets, closets or a hallway
  • A drain or toilet backed up
  • A damp smell stays after the floor feels dry

These point to water inside the building materials. Surface drying will not reach it.

Clean water, gray water and sewage: the three categories

Category 1Clean source: a supply line, faucet or water heater.
Category 2Significant contamination: for example, washer or dishwasher discharge.
Category 3Grossly contaminated: sewage, rising rivers or streams.

The IICRC splits water into three categories. Its examples of grossly contaminated Category 3 water include sewage, waste line backflows from beyond a trap, seawater flooding, rising rivers or streams and contaminated wind-driven rain[IICRC 2026 position statement].

The category decides the order of work. Category 1 drying can start right away, while Category 2 and 3 losses get cleaned up under contamination controls before drying begins[IICRC 2026 position statement]. Storm water is not automatically Category 3; the restorer decides after inspecting[IICRC 2026 position statement].

Time matters too. The IICRC notes that time and temperature can change the category[IICRC 2026 position statement], so a clean leak left sitting for days can be treated as contaminated water.

The drying equipment and what it does

  • Pumps and extractors. Submersible pumps remove deep water. Extraction wands and weighted tools pull water out of carpet and pad.
  • Air movers. Fans set at angles along walls and floors move air across wet materials.
  • Dehumidifiers. Remove water from the air. Without them, air movers just push damp air around the room.
  • Moisture meters. Measure the water in drywall, framing and subfloor, and confirm when each area is dry.
  • Infrared cameras. Help locate wet areas behind finished surfaces, with meters used to confirm.
  • Containment. Plastic sheeting closes off the work area, which keeps contaminated water and drying air where they belong.

Saving belongings and materials after water damage

Two questions decide it: was the water clean, and how fast can the item dry? Wet materials that cannot be cleaned and dried within 24 to 48 hours should be thrown out, according to the EPA[EPA flood cleanup guide]. With floodwater, the CDC says to throw away items that cannot be disinfected, like wall coverings, cloth, rugs and drywall[CDC].

Clean-water losses give you more options. The EPA says drywall, fiberglass insulation and carpet soaked only with clean water can sometimes be dried and kept, but it also suggests considering replacement because they dry slowly[EPA flood cleanup guide].

Take photos and video of damaged items before they are removed[FEMA].

Earthquakes, water heaters and broken lines

On January 17, 1994, the magnitude 6.7 Northridge earthquake hit on a blind thrust fault under the San Fernando Valley[USGS]. The USGS puts property damage at about 40 billion dollars, with more than 7,000 people injured[USGS].

The USGS notes that strong shaking can topple water heaters and break water mains[USGS]. California law requires all residential water heaters to be braced, anchored or strapped to resist falling or moving in an earthquake[California Health and Safety Code 19211], and the Division of the State Architect calls for at least two sets of straps on a typical tank[California DSA].

Gas water heater with two earthquake straps and a small puddle on the garage floor

Once the shaking stops and it is safe to move around, look for running water at the water heater, toilets and sink lines, and close the main shut-off if anything is leaking.

Toilet and drain backups

Sewage is Category 3 water[IICRC 2026 position statement]. Keep children and pets out of the area, do not run fans that blow air from the wet room into the rest of the house, and do not try to dry it in place. Soaked carpet, pad and drywall are removed and the area is cleaned and disinfected before drying.

LA Sanitation explains the split: the city owns the sewer main, and the private lateral from the house to the middle of the street is the owner’s responsibility. When any plumbing fixture in the home sits below the street manhole cover, a backwater valve is required, permitted through the Department of Building and Safety[LA Sanitation].

Talking to the restoration company

  • What category is the water, and how does that change the plan?
  • Where did the moisture meter show water, and how far did it spread?
  • What needs to be removed, and why can it not be dried?
  • How many dehumidifiers and air movers will run, and how often will someone check readings?
  • Will I get a written scope and daily drying logs?
  • Can you show your California contractor license?

A good restoration company will answer these without hesitating and will take readings before giving a plan.

Once the house is dry

Ask for a copy of the final readings and keep them with your damage photos. In the weeks after, watch for a damp smell, new stains or swelling floors. Fix the source for good; the EPA is clear that the water problem must be fixed or it comes back[EPA].

Water extraction by community

Water extraction

Call to be connected with an independent restoration company.

Call (855) 671-4316
Call (855) 671-4316